Setup guide

Chapter 3 Installing and Configuring the Cisco Secure ACS Appliance
Installing the Cisco Secure ACS Appliance
3-12
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Step 4 Connect a console to the serial port on the back panel. To connect the console to
the terminal port:
a. Attach a DB-9 to RJ-45 adapter (provided) to the serial port on the console.
b. Attach a DB-9 to RJ-45 adapter (provided) to the console serial port on the
back panel of the Cisco Secure ACS Appliance.
c. Connect the console to the Cisco Secure ACS Appliance using an RJ-45 cable
(provided).
d. Route the RJ45 cable through the cable clamp.
Note The console terminal must be set to the VT 100 mode with 115200 baud,
8 bits, no parity, stops 1, and no flow control.
Step 5 When you have finished routing cables through the open cable clamp, loosen the
cable clamp thumbnuts, slide the jaws of the cable clamp together, and retighten
the cable clamp thumbnuts to secure the cables. See Figure 3-6.
Figure 3-6 Cable Clamp
114001