Setup guide

3-11
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Chapter 3 Installing and Configuring the Cisco Secure ACS Appliance
Installing the Cisco Secure ACS Appliance
Figure 3-5 Chassis Attachment to Cable Tray
Connecting Cables
Use unshielded twisted pair (UTP) copper wire Ethernet cable, with standard
RJ-45 compatible plugs, to connect Cisco Secure ACS Appliance to the network.
To connect the cables, follow these steps:
Warning Do not work on the system or connect or disconnect cables during periods of
lightning activity.
Step 1 Plug the network connection into the Ethernet port for NIC 1. For the location of
the Ethernet port, see Figure 1-3 on page 1-5. The NIC is configured to
automatically detect the speed and duplex mode of the network.
Tip The Ethernet port for NIC 1 is the lower of the two Ethernet ports. Only one
Ethernet port can be used at one time.
Step 2 Loosen the cable clamp thumbnuts to open the cable clamp jaws and then tighten
the thumbnuts to secure the jaws in the open position.
Step 3 Route the Ethernet cable through the cable clamp jaws.
104986
1
2