Setup guide

3-7
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Chapter 3 Installing and Configuring the Cisco Secure ACS Appliance
Installing the Cisco Secure ACS Appliance
To install the Cisco Secure ACS Appliance in a rack, follow these steps:
Step 1 Attach the rack rails to the rack:
a. Loosen the thumbnuts on each of the two rack rails provided.
b. Adjust the length of the rack rails so that the endplates fit outside the rack
posts both in front and in the rear.
See Figure 3-2 for proper positioning of rack rails and endplates.
Note Ensure that the rack rails are positioned so that they are level, the
thumbnuts and endplates are facing out, and the rails are to the inside
of the rack posts.
c. Using 8 screws that you provide, appropriate to the size of your rack (1/4-20
or M6 thread size suggested), fasten the front and back endplates of each rack
rail to the front and back of the rack.
d. Tighten the thumbnuts on both rack rails.