Setup guide

Chapter 3 Installing and Configuring the Cisco Secure ACS Appliance
Installing the Cisco Secure ACS Appliance
3-6
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Step 3 Hold down the two latches on the top of the access panel while sliding it toward
the rear of the unit (about half an inch).
Step 4 Lift and remove the access panel.
Tip Reverse this procedure to reattach the access panel.
Installing the Cisco Secure ACS Appliance in a Rack
Cisco Secure ACS Appliance rack installation entails attaching rack rails, two
different cable tray assembly components, and the unit itself to your existing
equipment rack. See Figure 3-1 for a view of the final installation configuration
from the rear and for the names of the parts.
Figure 3-1 Installation Overview - Rear View
1 Latches on chassis access panel 4 Fixed cable tray support bracket thumbnut
2 Hook on support bracket 5 Cable clamp thumbnuts
3 Cable support bracket thumbnut 6 Fixed cable tray rail thumbnut
5
6
4
3
2
1
104984