Setup guide

3-5
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Chapter 3 Installing and Configuring the Cisco Secure ACS Appliance
Installing the Cisco Secure ACS Appliance
• Connecting to Power Source, page 3-13
• Powering On the Cisco Secure ACS Appliance, page 3-13
Accessing Internal Components
The Cisco Secure ACS Appliance access panel can be removed to gain access to
internal components or to allow clearance for attaching the optional cable support
bracket.
Warning Before working on a system that has an on/off switch, turn OFF the power and
unplug the power cord.
Warning Before working on a chassis or working near power supplies, unplug the power
cord on AC units.
Warning Before opening the chassis, disconnect the telephone-network cables to avoid
contact with telephone-network voltages
Warning The safety cover is an integral part of the product. Do not operate the unit
without the safety cover installed. Operating the unit without the cover in place
will invalidate the safety approvals and pose a risk of fire and electrical
hazards.
Caution Electrostatic discharge can damage electronic components. Be sure you are
properly grounded if you may come in contact with components.
To remove the Cisco Secure ACS Appliance access panel, follow these steps:
Step 1 Ensure that the Cisco Secure ACS Appliance is powered down and disconnected
from the electrical outlet.
Step 2 Disconnect from network cabling.