Manualshelf

Setup guide

ManualsBrandsBlack Box ManualsComputer equipmentACS111
41424344454647484950
2-5
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Chapter 2 Preparing for Installation
Safety
• Do not push any objects into the openings of your system components. Doing
so can cause fire or electric shock by shorting out interior components.
• Position system cables and power cables carefully; route system cables and
the power cable and plug so that they cannot be stepped on or tripped over.
Be sure that nothing rests on your system components’ cables or power cable.
• Do not modify power cables or plugs. Consult a licensed electrician or your
power company for site modifications. Always follow your local/national
wiring rules.
• To help avoid possible damage to the system board, wait 5 seconds after
turning off the system before removing a component from the system board
or disconnecting a peripheral device from the computer.
Maintaining Safety with Electricity
Follow these guidelines when working on equipment powered by electricity:
• If any of the following conditions occur contact the Cisco Technical
Assistance Center:
–
The power cable or plug is damaged.
–
An object has fallen into the product.
–
The product has been exposed to water.
–
The product has been dropped or damaged.
–
The product does not operate correctly when you follow the operating
instructions.
• Use the correct external power source. Operate the product only from the type
of power source indicated on the electrical ratings label. If you are not sure
of the type of power source required, consult the Cisco Technical Assistance
Center or a local power company.
• Use only approved power cable(s). You have been provided with a power
cable for your Cisco Secure ACS Appliance that is intended for your system
(approved for use in your country, based on the shipping location). Should
you have to purchase a power cable, ensure that it is rated for the product and
for the voltage and current marked on the product’s electrical ratings label.
The voltage and current rating of the cable should be greater than the ratings
marked on the product.