Setup guide

Chapter 2 Preparing for Installation
Safety
2-4
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Warning Ultimate disposal of this product should be handled according to all national
laws and regulations.
Warning Before working on a system that has an On/Off switch, turn OFF the power and
unplug the power cord.
Warning Read the installation instructions before you connect the system to its power
source.
Warning The ports labeled “10BaseT”, “100BaseTX,” and “1000BaseTX” are safety
extra-low voltage (SELV) circuits. SELV circuits should only be connected to
other SELV circuits. Avoid connecting these circuits to telephone network
voltage (TNV) circuits.
Warning There is the danger of explosion if the battery is replaced incorrectly. Replace
the battery only with the same or equivalent type recommended by the
manufacturer. Dispose of used batteries according to the manufacturer’s
instructions.
General Precautions
Observe the following general precautions when using and working with your
system:
• Keep your system components away from radiators and heat sources, and do
not block cooling vents.
• Do not spill food or liquids on your system components, and never operate
the product in a wet environment. If the computer gets wet, see the
appropriate chapter in your troubleshooting guide or contact the Cisco
Technical Assistance Center. For instructions on contacting the Technical
Assistance Center, see Obtaining Technical Assistance, page xxiv, in the
Preface.