Setup guide

2-3
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Chapter 2 Preparing for Installation
Safety
Warning Only trained and qualified personnel should install, replace, or service this
equipment.
Warning This unit might have more than one power cord. To reduce the risk of electrical
shock, disconnect all power supply cords before servicing the unit.
Warning This product relies on the building’s installation for short-circuit (overcurrent)
protection. Make sure that a fuse or circuit breaker no larger than 120 VAC,
15A U.S. and 240 VAC, 10A international are used on the phase conductors (all
current-carrying conductors).
Warning This equipment is intended to be grounded. Ensure that the host is connected to
earth ground during normal use.
Warning Blank faceplates and cover panels serve three important functions: they
prevent exposure to hazardous voltages and currents inside the chassis; they
contain electromagnetic interference (EMI) that might disrupt other equipment;
and they direct the flow of cooling air through the chassis. Do not operate the
system unless all cards, faceplates, front covers, and rear covers are in place
Warning Do not work on the system or connect or disconnect cables during periods of
lightning activity.
Warning Before working on equipment that is connected to power lines, remove jewelry
(including rings, necklaces, and watches). Metal objects will heat up when
connected to power and ground and can cause serious burns or weld the metal
object to the terminals.