Setup guide

Chapter 1 Cisco Secure ACS Appliance Overview
Cisco Secure ACS Appliance Hardware Description
1-8
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
The Ethernet connectors are designed for attaching an unshielded twisted pair
(UTP) Ethernet cable equipped with standard RJ-45 compatible plugs. Press one
end of the UTP cable into the Ethernet connector until the plug snaps securely into
place. Connect the other end of the cable to an RJ-45 port on a hub or other device,
depending on your network configuration. Observe the following cabling
restrictions for 10BASE-T, 100BASE-TX, and 1000BASE-TX networks:
• For 10BASE-T networks, use Category 3 or greater wiring and connectors.
• For 100BASE-TX and 1000BASE-TX networks, use Category 5 or greater
wiring and connectors.
• The maximum cable run length is 328 feet (ft) or 100 meters (m).