Setup guide

1-7
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Chapter 1 Cisco Secure ACS Appliance Overview
Cisco Secure ACS Appliance Hardware Description
Ethernet Connectors
Your system has two integrated 10/100/1000–megabit-per-second (Mbps)
Ethernet connectors. Cisco Secure ACS Appliance supports the operation of
either Ethernet connector, but not both connectors. Each Ethernet connector
provides all the functions of a network expansion card and supports the
10BASE-T, 100BASE-TX, and 1000BASE-TX Ethernet standards.
Each NIC is configured to automatically detect the speed and duplex mode of the
network.
Note The Cisco Secure ACS Appliance supports the operation of only one Ethernet
connector at a time. Concurrent operation of both Ethernet connectors is not
supported.
Network Cable Requirements
8 CTS I Clear to send
9 RI I Ring indicator
Shell N/A N/A Chassis ground
Pin Signal I/O Definition
Warning To avoid electric shock, do not connect safety extra-low voltage (SELV)
circuits to telephone-network voltage (TNV) circuits. LAN ports contain SELV
circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports both
use RJ-45 connectors. Use caution when connecting cables.