Setup guide

Chapter 4 Administering the Cisco Secure ACS Appliance
Upgrading the Appliance
4-32
Installation and Setup Guide for Cisco Secure ACS Appliance
78-14573-02
Step 3 Press Enter.
Result: The system displays the following confirmation message:
You should reboot appliance for the change to take effect.
Setting the Appliance System Hostname
Caution Performing this procedure stops and restarts all services and will interrupt use of
the Cisco Secure ACS Appliance.
You can set the system hostname. To set the Cisco Secure ACS Appliance system
hostname, follow these steps:
Step 1 Log on to the Cisco Secure ACS Appliance. For more information, see Logging
On to the Appliance via Serial Console, page 4-2.
Step 2 At the system prompt, type set hostname followed by a single space and the
hostname.
Tip You can use up to 15 letters and numbers but no spaces.
Step 3 Press Enter.
Result: The system restarts all services and the hostname is reset.
Upgrading the Appliance
This section describes how to load and install a Cisco Secure ACS Appliance
upgrade image from the command line interface of the serial console.