Specifications

5
SECTION A
SETUP & INSTALLATION
Setup
1. Fully unpack all of the boxes that accompany this changer. This should include the box containing the
changer and this manual, the box containing the battery, and any extra boxes that may contain the
Bill Box, Battery Charger, or additional spare batteries, etc.
2. Open the door to the changer. For the Cam Lock
, use the keys that are enclosed in the manila
envelope accompanying this manual. Insert the key, and then rotate it clockwise ¼ turn to unlock the
door. For the T-handle, the lock is not installed yet (refer to step 9 for lock installation). Turn the
handle counter-clockwise, up to 10 times or more, until the screw disengages from the lock bracket.
3. Visually inspect the changer’s interior for any obvious damage that may have occurred during
shipping, including dislodged components or detached connectors. NOTE: The white two-position
battery connector will be detached, as the battery is shipped in a separate box.
4. If no damage is found, install the battery in the cabinet. The battery should be placed on top of the
metal platform located in the top left corner of the cabinet, above the Battery Hopper.
5. Before permanent installation of your AC401 changer, perform a functional test to further verify that
there is no hidden shipping damage. To ready the changer for use, coins must first be added to the
hopper. You will need at least enough coins to cover the two metal plates at the bottom of the Coin
Bin, or approximately 100-150 coins. The Battery Hopper must also be powered-up. Connect the
white two-position battery connector, which is secured to the left side of the cabinet, to the mating
white connector attached to the top of the battery (refer to Figure 1 below). When this connection is
made, the hopper’s red LED should light up for approximately two seconds. When the LED turns off,
the changer is ready for testing.
6. AC401: Insert the Bill Box inside the changer. It should slide in to the right of the hopper, with its
bottom resting on the two studs protruding from the right interior wall. The part on the top of the Bill
Box that sticks out toward the left should be covering the hopper’s Coin Bin to block accepted bills
from falling into it.
AC401-COIN
: Insert the Coin Box inside the changer. It should fit into the space on the bottom of the
cabinet to the right of the hopper, underneath the coin acceptor. When the changer’s front door is
closed, all accepted coins should fall down directly into the Coin Box.
7. Close the front door, and insert a few bills or coins to ensure the machine pays out correctly. To
change the payout, refer to the “Payout Selection” section of this manual.
8. Once the changer has been tested and is working properly, please completely charge the battery
before installing the changer in its permanent location.
9. Installing the T-handle lock: The lock and keys can be found inside the manila envelope
accompanying this manual. To install the lock, insert the cylinder into the round hole in the middle of
the T-handle, pushing it all the way in until it stops. Rotate the cylinder until you hear it ‘snap’ into
place. Turn the key counterclockwise ¼ turn, and remove the keys.
Figure 1
–
Battery (
top view
)
FUSE
CONN
ECT



To Battery
To Battery
Hopper
For more information visit www.Gumball.com | 800-260-0010 | [phone]