Specifications

13
To Program A Coin/Token For Acceptance
Only ONE coin can be programmed into each “window” of the Coin Acceptor. Use Table 2 to identify the
proper “window” into which to program the coin, based on the desired payout. NOTE: Do not program the
same coin into multiple positions. This will result in the coin being rejected.
1. Make sure the acceptor’s LED is solid green before proceeding.
2. Turn the Rotary Switch to the proper position for the desired payout (refer to Table 2). Examples:
For £1 = 5 x 20p
, use position 5, with the hopper payout set to 1 coin per dollar (refer to Figure 5).
For €1 = 2 x 50c, use position 2, with the hopper payout set to 1 coin per dollar (refer to Figure 5).
For £2 = 20 x 10p, use position 5, with the hopper payout set to 4 coins per dollar (refer to Figure 5).
3. Press the Program Button once; the LED should turn solid red.
4. Pass the required number of coins (typically 8) through the acceptor. For best results, use as many
sample coins as possible, rather than just one. When enough coins have been passed, the LED will
begin flashing green. NOTE: If the LED has not begun flashing green by the time 20 coins have been
passed through, the procedure has failed. Press the Program Button once (the LED will return to solid
green), recheck the sample coins, and restart the procedure.
5. Press the Program Button once; the LED should return to solid green.
6. Turn the Rotary Switch to position 0.
To Change the ENABLE Setting to “Low-Enable”
This procedure is usually performed at the American Changer factory, so, under most circumstances, it
will not be required. However, if you are using a Condor Plus/Premier purchased separately (outside of an
AC401 machine), and it is: (A) powering on correctly, (B) programming correctly, and (C) rejects all
coins, then this procedure may be attempted. NOTE: It only needs to be performed once to be effective.
1. Turn the Rotary Switch to position 0, and make sure the LED is solid green before proceeding.
2. Press and hold the Program Button until the LED begins to flash yellow, and then release it.
3. With the LED still flashing yellow, turn the Rotary Switch to position 5.
4. Press the Program Button once; the LED should begin flashing between yellow and green.
5. Turn the Rotary Switch to position C.
Table 2
–
Condor Plus/Premier Coin
Window Selection
Rotary
Switch
Position
(“Window”)
Payout A
(1Coin/Dollar)
Payout B
(4Coins/Dollar)
1 1 4
2 2 8
3 3 12
4 4 16
5 5 20
6 6 24
7 7 28
8 8 32
9 9 36
A 10 40
B 11 44
C 12 48
For more information visit www.Gumball.com | 800-260-0010 | [phone]