Troubleshooting guide

6
Indicator Lights
Main Logic Board:
1. Green LED on: AC power applied to the logic
board. All fuses are good.
2. Red LED
A. Heartbeat - 5 and 12vdc present. The changer is in
standby waiting for a bill pulse.
B. On Steady - Out of service, Hopper error detected.
Validator logic board:
1. Red LED
A. On Steady - Standby Mode, waiting for bill
insertion.
B. Flashing - Error mode, go to page for error code
information.
C. Off - The changer “Empty” LED is lit.
WIRE HARNESS COLOR AND DEFINITIONS
Validator harness:
Red - Switched Hot 120VAC.
White - Neutral 120VAC.
Black - 120VAC Low current validator enable.
Yellow - +5vdc credit pulse line.
Blue - -5vdc credit pulse line.
Orange - +12vdc Empty LED.
Brown - -12vdc Empty LED.
Hopper Harness
Yellow - Coin counting optic status line.
White - Low coin sense (+5vdc).
Brown - Low coin sense (-5vdc).
Black(s) - - 24vdc Motor supply voltage.
Orange - +24vdc Motor supply voltage.
SETTINGS FOR THE AC400 ONLY!
AC500 ONLY!
CoinCo MAGPRO Series Flash Codes
Flash codes 1-18 may appear during normal servicing of the
BA30. If more than one error or condition exists, the lower
number flash code will appear until its respective error or
condition is corrected. The left and right sensors referenced
below are given viewing the BA30 from the front.
# of Flashes Description of Flash Codes
1 Bill box full
2 N/A
3 Check bill path
4 All bill accept switches are off
5 Bill jam or sensor error
6 Stacker motor/home sensor
7 Transport motor/encoder sensor
8 N/A
9 EPROM Has Failed
10 EPROM Has Failed
11 Center Optic Failed
12 Right Optic Failed
13 Left Optic Failed
14 Bill Position Sensor Error
15 Right Bill Position Sensor Error
16 Left Bill Position Sensor Error
17 Lower Anti-Stringing Armature out of place
18 Upper Anti-Stringing Armature out of place