Specifications

29
6. GEAR BOX ASSEMBLY
1. Remove the end plate. Section 6.
2. Remove the ‘elevator track’ & ‘final drive gear’.
Section 7.
3. Remove the gearbox cover. Section 8.
4. Remove the gears in the order as shown in FIG 9.
Access to the motor fixing screws is now possible.
5. To re-assemble, follow the above steps in reverse.
7. MOTOR REPLACEMENT
1. Remove the ‘coin box’. Section 1.
2. Unsolder the red & black wires from the motor.
NOTE: The black wire connects to the terminal
marked with a RED dot.
3. Remove the ‘end plate’. Section 6.
4. Remove the ‘track plate’ & final drive gear.
Section 7.
5. Remove the gearbox cover. Section 8.
6. Disassemble the gearbox. Section 9.
7. Unscrew the 2 motor fixing screws. FIG 10.
8. To re-assemble, follow the above steps in reverse