Specifications

26
3. LOGIC BOARD REPLACEMENT
1. First, remove the ‘coin box’, section 1.
This will then enable access to the ‘logic board’.
10-way ribbon IDC socket (CONN 1).
2. Move the two ejector arms at right angles to & away
from the connector, if fitted.
3. This should release the socket from the header.
4. Clasping the connector between thumb & forefinger,
pull away from pin header.
14-way crimp socket (CONN 2).
5. Gently, unclip the “friction lock” from the connector
housing.
6. Clasping the connector between thumb & forefinger,
pull away from pin header.
7. The Logic Board is now released.
8. To re-assemble, follow the above steps in reverse.
4. END PLATE REMOVAL
1. Place the hopper in front of you as shown, (looking at
the outside of the ‘end plate’).
Refer to FIG 6.
2. Remove the 9 screws indicated (B), which hold the ‘end
plate’ to the ‘center plate’.
3. Locate the position of the ‘connector blanking piece’.
4. Holding the ‘connector blanking plate’ gently lift the
‘end plate’ away from the rest of the hopper.
5. To re-assemble, follow the above steps in reverse.
5. TRACK PLATE REMOVAL
1. 1. First, remove the ‘end plate’, section 6.
See FIG 7.
2. The ‘elevator track’ & ‘final drive gear’ can now
be removed by lifting up & away from the ‘center
plate’.