Specifications

25
COIN BOX ASSEMBLY (cont.)
2. Line up the ‘centre plate’ & ‘coin box’ as shown below.
FIG 12a.
3. Route the ribbon cable as shown below.
4. Fit the ‘logic board’ into slots shown below.
5. Feed the level sense wires through the slot shown
below.
6. Lift the ‘centre plate’ to meet the ‘coin box’. FIG 12b &
c.
7. Align the ‘center plate’ & ‘coin box’ & push together.
8. Turn the hopper over & refit the screws.
9. Refit the level sense wires.
2. EXIT WINDOW REPLACEMENT
1. First, remove the ‘coin box’, section 1.
This will then enable access to the ‘exit window’
2. Unscrew & remove the 2 fixing screws. FIG 4.
3. Remove the ‘exit window’ from the ‘center plate’.
4. Unclip & remove the 10-way ribbon cable header.
5. To re-assemble, follow the above steps in reverse.