Specifications

Compact CAT5 Audio/Video Receiver

CAUTION

Before plugging in your remote monitor, verify that the AC line is

properly wired and that a protective ground (green) wire is

established with NO potential difference between both the sender

and Receiver locations (The UTP Splitter can tolerate up to 5 v peak-

to-peak ground noise between the two locations) . Failure to ensure

good grounding can result in erratic operation and possible shock

hazards with severe damage to your equipment.

NOTICE

Do not connect this unit to any LAN device such as network cards or

hubs as this may damage the AC155A-R2 and/or the LAN device.

Use EIA/TIA 568B standard straight-through patch wiring as shown

below. Do not use crossover cables.

EIA/TIA 568B WIRING STANDARD

PIN Wire Color

1 White w/ Orange Stripe

2 Orange

3 White w/Green Stripe

4 Blue

5 White w/Blue Stripe

6 Green

7 White w/Brown Stripe

8 Brown

Tips on Cable Selection for Best Image Quality

The AC155A-R2 has compensation for high frequency losses in the cable.

However, due to the twist ratio difference in the UTP cable, it is

recommended to use UTP cables that are specifically designed for video

transmission. These cables are commonly referred to as zero or low skew

cables. Example: Belden Brilliance® VideoTwist™ 7987R/P. If you don’t

have access to this type of cable, we recommend using Cat5 (or Cat5e)

cable rather than Cat6 since Cat5 cables have better twist ratio match than

Cat6.