Specifications

PRODUCT SHEET
[e-mail]
[e-mail]
www.biopac.com
BIOPAC Hardware | MP150 Systems | Page 3 - 9 Updated: 2.25.2015
Device specs
MP150
Waveform Output Buffer: 500 K samples
Serial Interface Type/Rate: Ethernet: UDP (10M bits/sec)
Transmission Type: Ethernet
Maximum cable length: 100 meters (Ethernet cable)
Power Requirements: 12 VDC @ 2 amp (uses AC150A)
Dimensions: 10 cm x 11 cm x 19 cm
Weight: 1.0 kg
Operating Temperature Range:
0-70 C
Operating Humidity Range: 0-95%
OS Compatibility
Ethernet Interface
Windows
Mac
USB Interface
Windows
Mac
Windows XP, Vista, 7, 8
OS X
Not supported
Not supported
ISOLATION
Designed to satisfy the following Medical Safety Test Standards affiliated with IEC601-1:
Creepage and Air Clearance
Dielectric Strength
Patient Leakage Current
Contact BIOPAC for additional details.
SIGNAL CONDITIONING MODULE COMPATIBILITY
CO
2
100C EGG100C HLT100C PPG100C
DA100C EMG100C LDF100C RSP100C
EBI100C EOG100C MCE100C SKT100C
ECG100C ERS100C O
2
100C STM100C
EEG100C GSR100C OXY100C/E TEL100C
CLEANING PROCEDURES
Be sure to un
plug the power supply from the MP150 before cleaning. To clean the MP150, use a damp, soft cloth.
Abrasive cleaners are not recommended as they might damage the housing. Do not immerse the MP150 or any of
its components, as this can damage the system. Let the unit air-dry until it is safe to reconnect the power supply.
AC150/100A POWER SUPPLIES
The 12-volt in-line switching transform
er connects the MP unit to the AC mains wall outlet. One transformer is
included with each MP System; replacements can be ordered separately. These transformers are specified to
satisfy IEC60601-1 requirements and will accommodate 120-240 VAC (50/60 Hz) mains input.