Technical data

Page 9 of 52
Remote Control System
Take some time to learn about the remote system fitted to this fire.
This is operated by a fully sequential battery remote system. This is powered by
6 x AA batteries in the fireplace and a 9V battery in the handset.
The fire is operated by the Infra Red and the handset must be pointed directly
at the magic eye on the fire to work. It requires “line of sight”. Read the section
on lighting the fire for more information. The handset will switch the fire on/off
and regulate the flame up/down.
The hand set has a child safe feature to avoid accidental lighting. Please read
“lighting the fire” section later in this handbook before operating the appliance.
Note: that if the fire shuts down it is set in “safe mode” to reactivate
the fire press button #1 only on the handset. This will cause a beep.
Now the fire can be lit again using the standard start-up sequence.
The remote system has a fault diagnosis system built in which is indicated by a
number of beeps. Review the “fault diagnosis” section later in this manual for
the relevant code. A warning sound when the internal batteries become low will
be heard however if the batteries are totally dead there will be no sound. If the
appliance fails to operate on the hand set change the batteries in both the
appliance and the hand set as this is the most common cause of failure.
It is recommended that only “Lithium” batteries are used in the remote
system to ensure a long life. Never add old batteries as the alarm
system will sound. It will only reset with new batteries.
NEVER USE OLD BATTERIES. THE BLACK BOX HAS A “MEMORY” AND WILL
CONTINUE TO SOUND THE ALARM EVEN IF THE BATTERIES ARE CHANGED.
• TO RESET THE ALARM:
o TAKE OUT OLD BATTERIES AND WAIT 10 MINUTES
o FIT A BRAND NEW SET OF LITHIUM OR ALKALINE
BATTERIES
o THE ALARM WILL RESET.