Technical data

Page 46 of 52
How to Shutdown the fire if the Handset is Faulty or
Lost while the Fire is Lit
The appliance has a safety shut down switch which is built into the remote
system. This is in the form of a button fitted inside the appliance. In the
unlikely event that the wall switch is not fitted and the handset is lost,
damaged or broken while the fire is lit the fire can be shutdown by pressing
this button.
Safety Shutdown Procedure
• Carefully lift the front shelf taking care that the appliance will be hot.
• The reset button is fitted on the lower left edge of the remote shield.
(See images in the battery section)
• Carefully insert hand below the shelf taking care not to touch any hot
surfaces and press and hold the button for up to 60 seconds.
• The appliance will shut down.
• Taking great care not to touch any of the hot surfaces carefully remove
your hand and replace the front shelf.
• Do not use the appliance until the handset has been repaired or replaced.
•
To purchase a new handset call 01325-327221.
•
If the fire has been converted to mains operation the procedure is
the same however the power cable must be unplugged from the socket
which has replaced the reset button.
How to Reset The Fire
If the fire shuts down unexpectedly the valve will be locked in “safe mode” and
must be reset before the fire can be re-lighted. To do this press the “OFF”
button until a beep is heard. Then commence the starting sequence as detailed
above by pressing both left had buttons at the same time.
The pilot is a safety device which monitors the gas pressure and flue conditions.
If a fault in either of these areas are detected the pilot will shut the fire down.
If shutdown occurs again do not use the fire until it has been checked by a gas
installer.