Technical data

Page 18 of 44
The magic eye should now be installed as shown on page 19
Once all connections are made the burner should be tested for safe operation
and gas leaks.
For instruction on how to light the fire see the user section on page 25
Once tested the front shelf vanity cover should be fitted taking care not to
scratch the enclosure.
Fitting the Optional Fascia
If using with the optional fascia, fit the fascia to the fire before rendering the
wall around to ensure it fits. When rendering the wall up to the lower edge of
the front shelf leave a 10mm gap to allow the bottom tabs on the fascia to
locate with the underside of the front brackets on either side of the shelf.
Attach the fascia to the enclosure using the 5 countersunk screws provided.
Burner Unit
Note: The design has been changed with the burner carriage being fitted within
the complete enclosure this is to make installation easier. The images on the
next page show the carriage within the “old style” burner tray.
Note: The burner carriage can be taken out if required by removing the screws
securing the left and right front shelf brackets and removing the screws which
hold the carriage into the enclosure.