Technical data

Page 12 of 44
Remote Control System
The remote system is supplied with both the hard-wired wall mounted switch
and infrared hand held system as standard. Both options allow full control of
the fire – ON, OFF, UP, DOWN. The wall mounted switch and cable carries low
voltage, (20v). The colour code used in the switch wiring diagrams must not be
confused with normal mains colour coding.
Use and install both systems. This gives increased reliability and is
recommended by CVO. The removal of the remote components can lead to
accidental damage of the remote system which will not be covered by the
warranty. The magic eye is situated on the fascia and great care must be taken
on plugging this into the control board. When running the cabling for the
hardwire great care must be taken to ensure that the switch is wired correctly
(see image below taking notice of the “top” of the switch which is where the
Blue/Brown are attached.