Technical data

Page 9 of 56
General Installation Instructions
This fire is intended for decorative purposes. The installation must be in
accordance with National Regulations and all parts of the installation must be
carried out by a qualified GAS SAFE installer. Prior to installation, ensure that
the local distribution conditions (identification of the type of gas and pressure
and the adjustment of the appliance) are compatible.
The builders opening or fireplace opening must be constructed of a non-
combustible material. Clearances between the fire and all combustible
materials must conform to National Regulations. This fire must be installed
and used in accordance with these instructions.
For some countries a non-combustible hearth must be fitted in front of the fire
in accordance with National Regulations (e.g. United Kingdom).
The chimney must be swept before the appliance is installed. NOTE: If the
chimney is not swept, there is a possibility that loose debris will fall onto the
appliance which may result in damage and unnecessary service costs. Before
the fire is installed a flue test in accordance with National Regulations should
be carried out. The unit must not be installed unless the chimney / flue
length is at least the length and size indicated in 19.1 ‘Technical Data’. Under
no circumstances should this unit be installed and operated within any
premises without an adequate flue or chimney system. Any flue damper plate
or flue restrictor must be removed or fixed permanently in the fully open
position, or shall only be fitted in accordance with National Regulations.
The gas connections must be in accordance with National Regulations. An
isolation valve, or valves, has to be fitted adjacent to the appliance which,
when closed, allow(s) the complete burner and control assembly to be
disconnected for maintenance or repair in accordance with National
Regulations.
The pilot light and flame sensing device fitted to this fire is also an
atmosphere sensing devise. If for any reason any part of the pilot assembly is
to be replaced ALL the assembly including the pilot burner, thermocouple,
electrode and injector must be exchanged complete for an original
manufacturer’s pilot assembly only. This atmosphere sensing devise is not
adjustable and must not be put out of action. The pilot light shuts off both the
main burner and pilot if evacuation of the combustion products is interrupted.
If the fire shuts itself off, do not use the fire, and have the flue and fire
checked by a suitably qualified person. The correct method for re-lighting is
shown in ‘Re-setting the Appliance-
This appliance requires Outside Air Ventilation. Purpose provided air supply
must be fitted in accordance with National Regulations (e.g. United Kingdom -
minimum 100 cm2)