Technical data

Page 16 of 56
The gather supplied with the fireplace must be used. This can be inserted
into the fireplace opening and then lowered onto the enclosure before being
sealed in place with silicone fire cement.
The enclosure should be fitted within the opening with the front edge “flush”
with the final finished wall.
The enclosure once in place, should be drilled and secured to the fireplace
opening using plugs and screws. This should be done taking great not to
damage the burner or remote system.
The enclosure must be sealed to the finished wall and rendered etc ready for
the final assembly of stone enclosure.
The Stone. There are 13 pieces of stone supplied. The fireplace has been
fully assembled at the factory before being dismantled and packed. This
ensures that all pieces fit correctly.
Check the stone drawing on page 12
to identify each piece.
Check the stone assembly drawing on page 11
to see where the
pieces fit.
See Attached Installation Images of gather and stone assembly: