Network Hardware User Manual

724-746-5500 | blackbox.com
Chapter 5: Operation and Control
Page 17
5.3 Entering a Sequence of Commands on the Front Control Panel
Figure 5-1. Press the button for input channel number “1“. The LCD displays: ”1”.
Figure 5-2. Press the button for switching mode “AV“. The LCD displays “B”.
Figure 5-3. Press the button for the first output channel, number “3“. The LCD displays ”3”.
Figure 5-4. Press the ”Break” button: ”/”. The LCD displays a comma [”,“] to indicate a break between two channels
in a command.
Figure 5-5. Press the button for the second output channel, number “4“. The LCD displays “4“.
Figure 5-6. Press the button “END“ to finish the command. The LCD displays a period [“.“] to indicate that the sequence is
completed.
AVSW-DVI8x8