Installation guide

25
Pelican Micro Case
Note: The Pelican Micro Case is compatible with the Networkfleet 5200 device and the Universal Harness.
Installing the 5200 in the Pelican Micro Case
• Slide Universal Harness through the hole in the Pelican Micro Case.
• Connect the Harness to the unit
and place the unit into the form
fitting foam inside the Pelican
Micro Case.
• Pull harness completely through
so that there is no wire slack left
in the box.
• To completely ensure water
tightness, we recommend
adding a bead of silicone on
both the inside and outside of
the harness hole opening
• Let silicone dry, then close and
snap the lid shut
• Complete the connection of the harness to the vehicle found on page(s) 11-12.
Placement and Mounting of Pelican Micro Case
• The Pelican Micro Case and unit need to have a clear line of sight to the sky. Therefore, for the most reliable GPS
coverage, the case cannot be obstructed by any metal and should be mounted outside of the vehicle.
• Mounting the Case
o Completely clean and dry the area on the vehicle that you are going to mount the Micro Case
o To mount the case, remove protective film from the 3M High Bond tape on the back of the Micro Case
o Place case on vehicle per the noted mounting instruction above.
o Press down with firm pressure to ensure bond strength to the vehicle.
o **NOTE** 3M tape typically takes up to 72 hours to FULLY bond to both surfaces.