Installation guide

22
Port Expansion Module (PEM)
Note: To enable PEM functionality, the 5000 series device may need an over-
the-air firmware update. Customer Care will determine this during the installation
verification call.
As indicated on page 16, the PEM should NOT be installed over, or covering the
top of the Networkfleet unit with the logo.
Make appropriate connections to the PEM via the information below:
Connectivity Reference Table
IO-1
Future Functionality
IO-2 Future Functionality
HOST
Connection to the 5000 unit.
USB NMEA Feed For more information about the NMEA feed, read
the TIB: NMEA Feed.
DI-1 Digital input 1. This connector will host up to two sensors (pin
out compatible with 5000 series).
DI-2 Digital input 2. This connector will host up to two sensors (pin
out compatible with 5000 series).
DO
Future Functionality
SP-1 Serial port 1. This connector can host one or two accessories
(with a correct cable) for connecting external devices such as
Garmin FMI cable and Window-Mount GPS Antenna.
SP-2 Serial port 2. This connector can host one accessory for one
connecting external device such as Garmin FMI cable or
Window-Mount GPS Antenna.
Installation Process:
1. If the 5000 Series unit is already installed, unplug the unit and proceed with the following steps.
2. Move any existing Garmin FMI Cable or Window-Mount GPS Antenna connected to the 5000 device to the PEM
unit ports labeled SP-1 & SP-2.
3. Connect the HOST cable on the PEM unit to the 5000 Series unit serial port.
4. If sensors need to be installed, follow the instructions as indicated on pages 18-19.
5. Connect the 5000 Series unit to power and perform installation verification with Networkfleet Customer Care.