Specifications

CHAPTER 2: Introduction
7
Accessories that you will need to purchase include:
• 12-24 or 10-32 nuts/bolts
• Rear Bracket Extension Kit (RMB1–RMB5): These kits contains two rear brackets, two extensions, and two
end rails. Make sure you have the correct kit to fit the depth of your cabinet (see below).
NOTE
The following length is the depth measured between the front pole and rear pole inside
a rack cabinet, not
the outside depth of a rack cabinet enclosure.
Depth RMB1 RMB2 RMB3 RMB4 RMB5
inch cm inch cm inch cm inch cm inch cm
Minimum 19.5 49.5 22.625 57.5 26.625 67.6 30.5 77.5 34.5 87.6
Maximum 22.375 56.8 27.75 70.5 31.625 80.3 35.625 90.5 39.5 100.3
• EHN408-0010 CPU cable to connect your PS/2 server to the ServTray.
Figure 2-2 shows the Rear Bracket Extension Kit, and Figure 2-3 shows the ServTray in its minimum and
maximum extension positions.
Figure 2-2. Rear Bracket Extension Kit.
Figure 2-3. The ServTray’s minimum and maximum depths.
19.5"D
(49.5 cm)
39.5"D
(100.3 cm)
Front
Front
Rear
Rear
(2) Rear
brackets
(2) Extensions
(2) End rails