Technical data

Installing Virtual COM Port
Documentation Number: LES40xA-1105m Chapter 6 41
Black Box Corporation - 1000 Park Drive - Lawrence, PA 15055-1018
www.blackbox.com -- Tech Support and Ordering: 724-746-5500 - Fax: [phone]
C
C
h
h
a
a
p
p
t
t
e
e
r
r
6
6
:
:
I
I
N
N
S
S
T
T
A
A
L
L
L
L
I
I
N
N
G
G
V
V
I
I
R
R
T
T
U
U
A
A
L
L
C
C
O
O
M
M
P
P
O
O
R
R
T
T
S
S
The Virtual COM Port feature allows Windows platform software, using standard API
calls, to be used in an Ethernet application.
The
Install Virtual COM Port software adds a Serial Server (COM#) port to the
computer. This shows up in the
Device Manager. The COM number can be selected
from a list of available numbers. For example, in a computer already having a COM1
and COM2, COM3 to COM 254 are available for the Serial Server. It is recommended
that COM Port 5 or higher be selected. The virtual COM port looks like a standard
COM port to most Windows based applications which allows the software to open a
connection with the serial port located anywhere on the LAN/WAN. When using the
virtual COM port the
Serial Server is configured as a TCP or UDP Server.
Virtual COM Port Installation
Step 1: From the Windows Desktop, click:
Start → Programs → Serial Server → Serial Server
The
Search Setup window will appear.
Step 2: Select the
Search all reachable servers check box, then click OK.
Figure 27. The Search Setup Window
Installing Virtual COM Port
42 Chapter 6 Documentation Number: LES40xA-1105m
Black Box Corporation - 1000 Park Drive - Lawrence, PA 15055-1018
www.blackbox.com -- Tech Support and Ordering: 724-746-5500 - Fax: [phone]
The program searches the LAN for all available Serial Servers. When
complete, the
Found Server window appears and displays a list of the
servers that were found.
Figure 28. The Found Server Window
Step 3: Select the Serial Server at the IP Address to be mapped to a virtual
COM port, then click
OK.
Figure 29. The COMInst Window
Step 4: In the Map To: field, select the number of the virtual COM port to
be assigned. The default
Flow Control setting is None. RTS/CTS can be
selected if used by the application program and serial hardware. The Serial
Server must be set to match. The Protocol TCP/UDP, IP Address, and Port
Number will mirror the settings of the selected serial server. Click
OK.