Technical data

Server Properties Configuration
Documentation Number: LES40xA-1105m Chapter 5 39
Black Box Corporation - 1000 Park Drive - Lawrence, PA 15055-1018
www.blackbox.com -- Tech Support and Ordering: 724-746-5500 - Fax: [phone]
will take effect. Click Yes. After several seconds a dialogue box will ask
whether you want to search for all reachable servers again. Click Yes.
After that port has been updated you may want to re-enter
Server Properties
to verify the changes have taken effect, or to view/change the configuration
of other ports. Each port must be configured separately.
Saving Configuration Data in Console Mode or Telnet
Saving (updating) server properties is done from the Configuration screen.
Access the
Configuration screen by tabbing through the list of screens on the
left side of the window and highlighting
Configuration.
There are four options shown on the right side of the
Configuration screen:
Save, Default, Running and Reset. Use Tab, Backspace, or arrow keys to
move the cursor to the option position, and then press
Enter.
• Save stores the configuration data to the Serial Server flash memory and
resets it.
• Default restores the configuration data to factory default settings.
• Running restores the configuration data to the last values stored in the flash
memory.
• Reset re-boots the Serial Server, making it available for a client connection.
Web Server Interface
• The Web Server interface provides the same updating options as
Console Mode and Telnet. These are located at the bottom of all three
Web Server pages. If a field is changed, you must click Save before
leaving that page or the changes will be ignored.
N
N
o
o
t
t
e
e
:
:
If you leave any Web Server page without saving, any changes you have made
will be ignored.
Server Properties Configuration
40 Chapter 5 Documentation Number: LES40xA-1105m
Black Box Corporation - 1000 Park Drive - Lawrence, PA 15055-1018
www.blackbox.com -- Tech Support and Ordering: 724-746-5500 - Fax: [phone]