Owner's manual

11
CHAPTER 1: HEADLINE
1. 8 7 7. 8 7 7. 2 2 6 9 BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.8 77.87 7. 2269
CHAPTER 4: OPERATION
You can control the KVM switch via either front-panel pushbuttons or keyboard hotkeys.
4.1 FRONT-PANEL PUSHBUTTONS
Front-panel buttons allow you to directly control the KVM switching operation. Simply press the button to toggle to the selected
PC port (together with hub port control and/or audio/mic port, if binding is enabled). By default, PC port switching, hub port control
and audio/ mic port switching are bound together, unless you specify the audio to be fixed to a specific port.
4.2 KEYBOARD HOTKEYS
A keyboard hotkey sequence consists of at least three specific keystrokes: See the Quick Reference Guide in Chapter 5.
Hotkey sequence = [ScrLk]* + [ScrLk] * + Command key(s)
* User-definable = SCROLL LOCK, CAPS, ESC, F12 or NUM LOCK
Hotkey preceding sequence configuration: For users who want to use a preceding sequence other than two consecutive Scroll
Locks, there is also one convenient way to configure it.
1. Press ScrollLock + ScrollLock + H, then two beeps will signal readiness for new preceding sequence selection [or Press and hold
down the last front-panel button (Button 2 or Button 4) until you hear two beeps, then release the button.]
2. Select and press the key you would like to use as your preceding sequence (SCROLL LOCK, CAPS, ESC, F12 or NUM LOCK keys
are available for selection) and you’ll hear a beep for selection confirmation. Now you can use the new preceding sequence to
execute your hotkey commands.
NOTE: Each keystroke within a hotkey sequence should be pressed within 2 seconds. Otherwise, the hotkey sequence will not be
validated.