Specifications

Model AC1120A, AC1121A, AC1122A, AC1123A

3.2.12.1 IP Setup Commands using the RS-232 Serial Port

IP interface on the matrix has a unique MAC-address, and it must be assigned a

valid IP-address to function properly on the network. As shipped from factory this

IP is 192.168.123.180

1. To get into the IP setting mode:

Note: Inactivity period of 16 seconds causes the system to exit this mode. You can also hit

ESC to end the IP setting mode.

Command: IP <cr> stands for IP setting mode

Response:

Enter IP commands:

This is the normal response meaning that IP setting through the RS-232 port is

allowed

- - - - - Alternate Response - - - - -

IP commands not enabled. Please refer to the manual

This message indicates that IP setting through the RS-232 port is disabled on your

unit. Please refer to section 3.2.12.2 below to enable this mode

2. To get the current IP address of the matrix box:

Command: GIP <cr> stands for Get IP address.

Response:

192.168.123.180

3. To set a new IP address:

Command: SIP192.168.123.179 <cr> stands for Set IP address.

Response:

OK ..................................................... if command completed successfully.

Error ...............................................................................if command failed.

4. To get the current gateway IP address:

Command: GGI <cr> stands for Get Gateway IP address.

Response:

192.168.123.122

5. To set a new gateway IP address:

Command: SGI192.168.123.125 <cr> stands for Set Gateway IP address.

Response:

OK ..................................................... if command completed successfully.

Error ...............................................................................if command failed.