Specifications

8x8 and 16x16 VGA / HDTV Matrix Switch with Audio, RS232 & IP Control
29
Matrix
Command
Processing
Port 1001
Port 23
IP Setup
Serial
Control
IP
Control
RS-232
Port
4. Command: XB,n <cr> Stands for X Baud
If n is not specified it reports the current baud rate (1-8).
n = 1, 2, 3, 4, 5, 6, 7, 8
Baud = 1200, 2400, 4800, 9600, 19.2k, 38.4k, 57.6k, 115.2k respectively
Response: XB,n <cr>
5. Command: XP,n <cr> Stands for X Parity
n = 0 1 2
Tranmit Parity to target = None, Odd, Even respectively
Response: XP,n <cr>
3.2.12 IP Control Basics
Figure 17 – Control Block Diagram
As shown in the figure above, the matrix can be controlled via RS232 Serial port
or through an IP (Ethernet) port if equipped. If the unit is missing the IP port, then
in its place, there is an auxiliary 2
nd
serial control port (see section 2.4.1).
The IP port of the matrix can be accessed via Telnet (interactive TCP connection).
Two ports are available, one for controlling the matrix and the other to configure
the IP parameters.
Though not recommended, using port 23 you can change the Ethernet interface’s
IP parameters such as IP address, gateway, port number, etc. The IP settings can
also be accessed through the unit’s RS232 serial port (recommended).
Port 1001 by default is used to control the matrix (this port number can be
changed as part of the IP Settings). The commands used to control the matrix are
the same as those through the RS-232 Serial port.