Specifications

8x8 and 16x16 VGA / HDTV Matrix Switch with Audio, RS232 & IP Control

At this point you have to decide if you want to view from the point of view of the

input side or the output side.

… To View from input side

Press and release any Input button, the backlit LED of that button will light, and

all the backlit LEDs for the outputs whose audio is currently tied to this input will

also light up solid.

You can now use the  and  buttons to quickly go through all inputs.

You can also make new ties by hitting output buttons. New ties will not take effect

unless ENTER is hit (see next section).

When you are done viewing ties, to exit you can hit ENTER. If you don’t hit any

buttons, then after 8 sec the view function times out and all the input and output

LEDs will go out.

… To View from output side

Press and release any output button, the backlit LED of that button will light, and

if that output’s audio is tied to any input; then that input LED will also light.

You can now use the  and  buttons to quickly go through all outputs.

You can also make new ties by hitting another input button. New ties will not take

effect unless ENTER is hit (see next section).

When you are done viewing ties, to exit you can hit ENTER. If you don’t hit any

buttons, then after 8 sec the view function times out and all the input and output

LEDs will go out.

3.1.2 Making Audio and Video Routings or “Ties”

This procedure is an extension of “Viewing Ties” described in above paragraphs.

3.1.2.1 Making a tie by Input

Video and Audio to follow each other

Make sure both VID and AUD LEDs are lit, indicating that your changes will be

synchronized (audio and video are together). Video and audio will be routed to the

same input channel.

Press and release any Input button, the backlit LED of that button will light, and

all the backlit LEDs for the outputs tied to it will light up solid. At this point,

pressing any output buttons will be breaking or making connections.

To disconnect a tie, press the lit output button once. To make new ties, press any

of the unlit output buttons. The output LED will be blinking to indicate a pending

change of state. If you change your mind simply press the blinking output LED

again and it will go back to its previous state.

When you are done, press ENTER to save new changes. If you wait too long (8

seconds of inactivity) your changes will be lost and all the input and output LEDs

will go out.

Video only or Audio only

Press and release the AUD and/or VID buttons so that the backlit LED of the

desired button is lit and the other one is off.

Follow the same procedure as described above