Specifications

ES10/ES26 Page 85/104
Document status: released Operating Manual rev. 01, 03.11.08
(master/slave mode, ref. to 7.17) this feature will automatically switch from the master TX
+ EDFA to the slave TX + EDFA. In this case the I/O No. 0 ports of both ES10/ES26 have
to be connected and the master/slave settings according to 7.17 have to be chosen. Note:
The requirements for an alarm condition can be set by adjusting the alarms thresholds as
explained in 7.18.
7.16 Changing Regulation Mode
The figure below shows, how to change the CSO regulation mode of the transmitter (not
available for ES10L). For details please refer to 3.2.
Fig. 7.16.1: Changing the CSO Regulation Mode of ES10/ES26