Specifications

ES10 Page 77/100
Document status: Released Operating Manual rev. 07, 25.09.13
6.5.3 Changing OMI
totrms
(AGC on mode only)
The figure below shows, how to adjust the RF OMI total rms, in order to optimize the transmission
performance in terms of CNR, CSO, CTB and BER. The RF OMI
totrms
is shown in %, enabling an
easy comparison e.g. with the graphs as shown in 4.3.
Fig. 6.5.4: Setting RF OMI
totrms
of ES10
Notes:
1. OMI nominal refers to a factory setting and cannot be changed by the user.
2. RF-OMI
totrms
setting is only relevant in AGC-on mode.
3. The setting range for RF-OMI
totrms
might change slightly from device to device due to
production tolerances.