Installation manual

9
Main switch
Steaming on C & K.
Preheating on B.
Exhaust open if
control lamp on.
Fan speed can be set between
20 and100%. Control lamp is
on when speed < 100.
HOT AIR selected if control
lamp on
Turn switch
COMBI STEAMING selected
if upper or middle control
lamp is on. REHEATING is
selected if lower control lamp
is on.
Program key
Step key
Alarm key
Start/Stop
Core temperature on C & K
Models. Injection time on
B model.
Change oven temperature
with turn switch
Change time with turn switch
START MENU
! Set temperature (press temperature key, temperature flashes, set temperature with turn switch, press
temperature key again to save).
! Set time (press time key, time flashes, set time with turn switch).
! Set core temperature (press core temperature key, set temperature with turn switch). C and K models
only.
! Set injection time (press injection key, time flashes, set injection time with turn switch). B model only.
Main switch
Not active
! To enter set-up mode, press hot-air key and steaming/preheating key for 2 sec.
! To leave set-up mode, turn switch to the left. Change between set-up and test mode by pressing combi-
steam key.
! The set-up mode is only intended for service engineers who wish to change the set-up of the computer
control of the oven model in question.
! The program display shows a description of the "U" function in question.
OVEN SET-UP
Confirmation of special
settings
Display shows setting
Display shows description of
“U” function
Display shows “U” No.
Not active
Display shows setting
Press HOT AIR and
STEAMING for 2 seconds
Possible to change to “d” test
mode with combi steam key
Press STEAMING/
PREHEATING and HOT AIR
for 2 seconds
Not active
Not active
Select “U” settings with
turn switch