Installation Instructions
Table Of Contents
- Introduction
- FCC Requirements
- Innovation, Science and Economic Development Canada Compliance
- Safety Precautions
- Information and Options
- Battery Installation and Removal
- Battery Care and Maintenance
- Antenna Installation and Removal
- Radio Controls
- LCD Display
- Programmable Switch and Button Functions
- Channel/Zone Selection Options
- Basic Radio Operation
- Command Zone Operation
- Code Guard/NAC Operation
- Mixed Mode Operation
- Trunking Channel Basic Operation
- Scan Options
- Pick List Options
- Unit-to-Unit Call Options
- Emergency Signaling Options
- Encryption Operation
- Messaging
- Paging and Call Alert
- Radio Inhibit/Enable [INH]/[UNINH]
- Other Options and Functions
- Backlight [LITE]
- Battery Life [LIFE]
- Bluetooth [BT]
- Busy Channel Operation
- Channel Select [CHAN]
- Cloning [CLON]
- Contrast
- Control Lockout [LCK]
- Date and Time [DATE]
- Global Positioning [GPS]
- Hard Power Down [PWRD]
- Keypad Programming
- Minimum Volume [VOL]
- Monitor [MON]
- Nuisance Channel Delete [DEL]
- Phone [PHN] and Hang Up [HANG]
- Radio Accountability Tone [RAT]
- Radio info
- Repeater Talkaround [T/A]
- Send Alert Tone [SNDT]
- Send Signal [SEND]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- System Test
- Transmit Digital [TXAD]
- Transmit Power [PWR]
- Two-Tone Select [TONE]
- Versions
- Zone Select [ZONE] (Conventional and Trunked Channels)
- Keypad Programming
- BK Technologies Warranty Information
- My Radio Settings
BK Technologies
- 62 -
User Selectable Network Access Codes
The BKR9000 can be pre-programmed with up to 32, user selectable
NACs. NACS are selected via a programmed button or menu item (see
TX/RX Network Access Code Picklist). If enabled, the tones can be
programmed via the radio’s keypad.
Select “User NACs” from the programing menu.
Select the NAC to edit.
Enter the desired value in hexadecimal (000 - FFF).
NOTE: $F7E and $F7F are invalid as user selectable NAC values.
User Selectable Talkgroup IDs
The BKR9000 can be pre-programmed with up to 32, user selectable
TGIDs. TGIDs are selected via a programmed button or menu item (see
Talk Group ID Picklist). If enabled, the TGIDs can be programmed via
the radio’s keypad.
Select “User TGIDs” from the programing menu.
Select the Talk Group ID to edit.
Enter the desired value (1 - 65535).
NOTE: A Talk Group ID value of 0 is not allowed.