Installation Instructions
Table Of Contents
- Introduction
- FCC Requirements
- Innovation, Science and Economic Development Canada Compliance
- Safety Precautions
- Information and Options
- Battery Installation and Removal
- Battery Care and Maintenance
- Antenna Installation and Removal
- Radio Controls
- LCD Display
- Programmable Switch and Button Functions
- Channel/Zone Selection Options
- Basic Radio Operation
- Command Zone Operation
- Code Guard/NAC Operation
- Mixed Mode Operation
- Trunking Channel Basic Operation
- Scan Options
- Pick List Options
- Unit-to-Unit Call Options
- Emergency Signaling Options
- Encryption Operation
- Messaging
- Paging and Call Alert
- Radio Inhibit/Enable [INH]/[UNINH]
- Other Options and Functions
- Backlight [LITE]
- Battery Life [LIFE]
- Bluetooth [BT]
- Busy Channel Operation
- Channel Select [CHAN]
- Cloning [CLON]
- Contrast
- Control Lockout [LCK]
- Date and Time [DATE]
- Global Positioning [GPS]
- Hard Power Down [PWRD]
- Keypad Programming
- Minimum Volume [VOL]
- Monitor [MON]
- Nuisance Channel Delete [DEL]
- Phone [PHN] and Hang Up [HANG]
- Radio Accountability Tone [RAT]
- Radio info
- Repeater Talkaround [T/A]
- Send Alert Tone [SNDT]
- Send Signal [SEND]
- Squelch Adjust [SQL]
- Site Display [STDS]
- Site Lock [STLK]
- Site Search [STSR]
- Surveillance Mode [SURV]
- System Test
- Transmit Digital [TXAD]
- Transmit Power [PWR]
- Two-Tone Select [TONE]
- Versions
- Zone Select [ZONE] (Conventional and Trunked Channels)
- Keypad Programming
- BK Technologies Warranty Information
- My Radio Settings
BK Technologies
- 54 -
Entering Keypad Programming Mode
To enter programming mode open the menu list by pressing the
assigned “Menu” button and select “Keypad Prog” from the menu list.
Use the keypad to enter the six-digit user or master password and press
the Enter button.
Select the item to program and press Enter.
Available programmable functions are:
Keypad - Used to edit individual channel and zone information such
as labels, frequencies, operating modes, etc.
Call List - Used to edit the P25 ID Call List entries.
User Tones - Used to edit the user selectable Code Guard entries.
User NACs - Used to edit user selectable Network Access Codes.
User TGIDs - Used to edit user selectable P25 Talk Groups
NOTE: Depending on PC programming, not all functions may be
accessible for keypad programming.
Global, System, Zone and Channel Parameters
The “Keypad” programming menu consists of four sub-menus for editing
global, system, zone and channel parameters (see table).
Keypad Programming Sub-Menus
Global System Zone Channel
Display Top Sys Pri 1 Add/Delete Add/Delete Rx/Tx NAC
Display Middle Tx on Pri 1 Label Label Sq Mode
Display Bottom Sys Pri 2 Zone Pri 1 Rx/Tx Freq Bandwidth
User Password Tx on Pri 1 Rx/Tx Mode Tx Power
Zone Pri 2 Rx/Tx Guard TGID
Global Settings
To edit the programmable Global settings, select “Keypad” from the
programing menu then select “Global” from the sub-menu.
Select the item you wish to edit from the Global menu.
Displayed Information Lines
The three main display lines can be programmed with the PC Radio