Owner`s manual

22 BK Radio
CG
label
9
Copy Code Guard
Values from Channel 9
CG
Label
5
Use Channel 9 Code
Gu
ar
d
V
al
ues
f
o
r
C
hann
e
l
USER SELECTED CODE GUARD
When the radio is being programmed with transmit and receive frequencies
for each channel, a receive Code Guard value and a transmit Code Guard
value can also be assigned to each channel. If User Code Guard Selection is
enabled, the Code Guard values for any channel can be copied to another
channel in the radio. If your channel selector does not have the same group
assigned to each position, the user-selected guard from the knob-selected
group will be linked with the knob-selected channel.
For example, to use the Code Guard values of
Channel 9 with the frequencies of Channel 5:
1. S
LIDE SWITCHES B AND C DOWN.
2. T
URN THE CHANNEL SELECTOR KNOB to
Channel 5.
3. PRESS THE 9 KEY on the keypad. The display
shows CG.
The radio will now operate on the
frequencies of Channel 5 with Channel 9
Code Guard values. The display shows the
Code Guard channel (9), and then the
selected channel (5).
4. PRESS THE # KEY to display the Code Guard
channel briefly. The display shows the group
number, followed by the Code Guard channel,
and then the selected channel.
5. PRESS THE 0 KEY to reset all values to the
original programming, or press different number
keys (1–16) to select a different set of Code
Guard values.
NOTE: During scan or priority scan, the display does
not show user-selected Code Guard values,
nor does it access user-selected Code Guard
values in scan mode.
NOTE: If the channel selector knob is on a different
group, when you rotate the knob, the new
group is programmed differently.
1 2 3
4 5 6
7 8 9
0
*
#
CLR
FCN
PRI
ENT