Service manual

GPH-CMD VHF Radio Installation and Programming
BK RADIO Page 2-15
9. Once the target and data to be transferred have been selected, press
the [FCN] key on the Master radio keypad. The top line of the display
will flash ‘CLONING’ while the program in the master is being
downloaded to the clone.
10. If the download was successful, the display on the Master will again
display the clone prompt (target and data to be transferred).
• To clone another channel group, press the Master radio’s [CLR]
key. Navigate to a ‘CH’ prompt, then press and hold the [#] key to
get the ‘GRP’ prompt.
• If cloning is finished, turn off the Clone and disconnect the cloning
cable. Normal radio operation will occur when you turn on the Clone.
11. If the download was not successful, the master will flash ‘FAILURE’ and
multiple beeps will follow. Failure of downloading can be due to:
• Improper connection
• Failure to turn on the clone
• Setting the clone in Programming Mode
• Target radio’s group ‘locked’ by PC Programming
NOTE: To stop the ‘FAILURE’ Mode, press [CLR], turn off both
radios, and try again, starting with Step 1 on the previous
page.
1 2 3
4 5 6
7 8 9
0
*
#
CLR
FCN
PRI
ENT
FAILURE
Group 01
CLONING
Group 01