Owner`s manual

38 BK Radio Programming Manual
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

$F7E
RX NAC
To enter hexadecimal characters A - F:
Each long press of the [2] key toggles the
right most character from A to B to C, then
back to A.
Each long press of the [3] key toggles the right most character from D
to E to F, then back to D.
To enter a ‘letter’ after another ‘letter’ or number, rst enter any
number, then toggle it with long [2] or [3] key presses.
The digital equivalent of carrier squelch is achieved by programming
the hexadecimal receive NAC to $F7E. The radio will unmute when a
digital signal with any NAC is detected.
Press [ENT] to store and return to the next value.
Squelch Mode (Digital models only)
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

SELECTIVE
SQUELCH MODE
This eld is the Receiver Squelch Mode for
Channel 1. This setting is only used if the
receive mode selected was Digital or Mixed,
or if User Channel Guard is activated. The
upper part of the display will show ‘PRG RX’.
Available modes are Normal and Selective.
Normal squelch opens on a matching NAC and ANY Talk Group ID or
Individual Unit ID.
Selective squelch requires the correct NAC and the correct Talk Group
ID, and for Unit-to-Unit calls, requires a matching Individual ID.
If the Squelch Mode is correct, press the [FCN] key to advance to the
next eld.
If a different Squelch Mode is desired, press the [PRI] key to toggle
the setting. Then press the [ENT] key to store this setting and
automatically advance to the next eld.
Transmit Frequency
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

151.625
TX FREQUENCY
This eld is the transmitter frequency for
Channel 1.
If it is correct, press the [FCN] key to
advance to the next eld.
If you wish to change it, press the [CLR] key followed by the frequency
in MHz, then [ENT] to store the new frequency and automatically
advance to the next eld.
Contents