Owner`s manual

RELM Wireless Corporation 33
Scan Delay
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

2.5 SEC
SCAN DELAY
This eld is the ‘SCAN DELAY’ time.
Press the [PRI] key to increase the scan
delay time by .5 seconds, up to 7.5 seconds.
Press the [PRI] key again to change the time
from 7.5 seconds to 0.
Press the [CLR] key to reset the scan delay time to 0.
Press the [ENT] key to store the changed setting and advance to the
next eld.
Press the [FCN] key to advance to the next eld if no change is needed.
Busy Channel Operation
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

LOCKOUT
BUSY CHANNEL
This step applies to DPH-CMD only.
Refer to “Option Group 2 - 2/3” for GPH-CMD.
There are three types of busy channel
operation available.
Busy Channel Modes include:
Busy Channel Indicator - The yellow LED illuminates when a signal
is received on the channel selected, with or without the programmed
receive Channel Guard setting.
Busy Channel Lockout - The yellow LED illuminates and the transmitter
PTT is disabled when a signal is received without the programmed
receive Channel Guard setting.
Busy Channel Override - This option is similar to Busy Channel Lockout
except the transmitter PTT can be activated by rotating the Squelch
knob clockwise off the Channel Guard detent.
Press the [PRI] key to cycle through the available settings.
Press the [ENT] key to store the changed setting and advance to the
next eld.
Press the [FCN] key to advance to the next eld if no change is needed.
ANI/DTMF Operation
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

DTMF ONLY
ANI/DTMF
This step applies to DPH-CMD only.
Refer to “Option Group 2 - 4/5” for GPH-
CMD.
Contents