Owner`s manual

32 BK Radio Programming Manual
Priority 1 Lock
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

USER SELECT
PRI-1 SELECT
This step applies to DPH-CMD only.
Refer to “Option Group 1 - 4” for GPH-CMD.
When PRI-1 SELECTION is set to LOCKED
OUT, the user will not be able to change
the designation of the Priority 1 Channel by selecting a channel and
pressing the [PRI] key.
When PRI-1 SELECTION is set to USER SELECT the user will be able
to change the channel that is designated as Priority 1 Channel.
Press [PRI] to toggle the option on or off.
Press [ENT] to store the setting and advance to the next eld.
Scan List Lock
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

USER SELECT
SCAN LIST
This step applies to DPH-CMD only.
Refer to “Option Group 1 - 5” for GPH-CMD.
When SCAN LIST SELECTION is set to
LOCKED OUT, the user will not be able to
use the [ENT] and [CLR] keys to add channels to and delete channels
from the Scan List.
When SCAN LIST SELECTION is set to USER SELECT, the user can
alter the Scan List using the [ENT] and [CLR] keys.
Press [PRI] to toggle the option on or off.
Press [ENT] to store the setting and advance to the next eld.
Transmit Time-out Timer
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

60 SEC
TX TIMEOUT
This eld is the ‘Transmitter Time-Out Timer’
setting. 0 SEC means the Time-Out Timer is
disabled.
Press the [PRI] key to increase the Time-
Out Timer duration by 15 seconds, with a maximum of 225 seconds (3
minutes, 45 seconds). Press the [PRI] key again to change the duration
from 225 seconds to zero.
Press the [CLR] key to set the Time-Out Timer duration to zero.
Press the [ENT] key to store the changed setting and advance to the
next eld.
Press the [FCN] key to advance to the next eld if no change is needed.
Contents