Owner`s manual

30 BK Radio Programming Manual
A new number can be entered by pressing number keys. The digits will
appear at the right of display and move to the left.
Press the [ENT] key to store the new ID number and advance to the next
section.
The existing ID number can be incremented one digit by pressing the
[PRI] key.
Press the [ENT] key to store the new ID number and advance to the next
eld.
Priority 1 Channel
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

CHANNEL XX
PRI-1 CHAN
This eld is the ‘Priority 1 Channel’. Any one
of the 500 channels in the radios can be
designated as the Priority 1 channel, or PRI-1
can be tied to the Channel Selector knob, or
programmed OFF. If the radio is programmed
to transmit on the rst priority channel, transmissions will occur on PRI-1,
if PRI-1 isn’t programmed OFF, when operating in Single or Dual Priority
Scan Mode.
If PRI-1 is a xed channel and the [PRI] key on the keypad is not locked
out during normal radio operation, the user can select a new group, if
necessary, move the channel selector to a new channel and press the
[PRI] key to choose a new PRI-1 channel.
Press the [PRI] key to cycle through the priority channel options.
Setting the channel to MAIN ties the PRI-1 channel to the Channel
Selector knob.
Press the [ENT] key to store the new priority channel and advance to the
next eld.
Priority 1 Group
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

GROUP XX
PRI-1 GROUP
If the Priority 1 channel has been programmed
as one of the 500 channels in the radio, the
group where the channel resides must be
designated. If PRI-1 has been tied to the
Channel Selector knob (set to MAIN), or
programmed OFF, the Priority Group eld is skipped.
Press the [PRI] key to cycle through the priority group options, or press
number keys to enter a group.
Press the [ENT] key to store the new priority group and advance to the
next eld.
Contents