Owner`s manual

RELM Wireless Corporation 29
Operation Option 2 Option 3
Indication Disable (Steady) Enable (Flashing)
Lockout Enable (Flashing) Enable (Flashing)
Override Enable (Flashing) Disable (Steady)
Options 2-4 & 5: ANI/DTMF Mode
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

2-12345678
GBL OPTIONS
When Option 4 is enabled (ashing), the
ANI ID number will be transmitted (as a
DTMF tone sequence) with each press of
the PTT switch. See “Automatic Numeric
Identication (ANI)” on the next page for
instructions on setting the ANI number.
When Option 5 is enabled (ashing), the keypad becomes active for
manual DTMF operation.
When Options 4 and 5 are both enabled (ashing), the ANI tone
sequence will be transmitted only after the [ENT] key is pressed while
the transmit PTT switch is activated. A sidetone of the ANI number
transmitted will also be heard through the speaker.
Options 2-6, 7 and 8: Reserved For Future Options
Once each option is set as desired, you can store the changes, discard
the changes, or disable all displayed options.
Press the [CLR] key to disable all displayed options (steady).
Press the [ENT] key to store new displayed options settings into
memory and advance to the next eld.
Press the [FCN] key to advance to the next eld without saving
changes.
Automatic Number Identication ID (ANI)
PRG TX RX SCN D CMND


home channel
T32 N4 G7
PRG TX RX SCN D CMND

ANI 1234567
ANI ID NUM
This eld is the ‘ANI ID’ number (as many as
seven digits may be used). The ID number
can be used for either radio management or
transmitted as a DTMF tone burst for ANI
purposes. The ANI can be enabled or disabled. See “ANI/DTMF Mode”.
If no change is needed for the ID number, press the [FCN] key to
advance to the next eld.
Contents