Owner`s manual

RELM Wireless Corporation 13
Group Labels
GROUP 1
PRG
After the backlight duration setting, the
display will show the current label for the
channel group. Each channel group can
have a label of up to eight characters or
spaces. The characters can include 0-9,
A-Z, -, *, $, /, +, %, \, |, _, <, >, h, or blank.
If no change is needed, press the [FCN] key to go back to the starting
point for Channel 0 settings.
Press the [CLR] key to erase the current label. Press the [CLR] key a
second time to restore the current label.
Changing The Group Label
Press the [CLR] key. The display becomes blank.
Press number keys to enter 0-9 in positions 1-7. The digits start in
position 7, then move left.
Press the [#] key to toggle a decimal on or off to the right of the
character in position 7.
The decimal moves left with the number in position 7 as new numbers
are entered.
Use the following steps to enter a number in position 8 or characters in
positions 1-8:
a. Press the [PRI] key repeatedly to cycle through characters
0-9, A-Z, -, *, $, /, +, %, \, |, _, <, >, h, blank, then back to the start
again.
If you pass the desired character, press the [PRI] key repeatedly
until you return to the start and reach that character again.
b. Press the [FCN] key to shift the display left by one position,
leaving position 8 blank.
c. Press the [PRI] key repeatedly to enter the next character, or
press the [FCN] key a second time to enter a blank space.
d. To abandon changes, press the [CLR] key, restoring the original
label.
Press the [ENT] key to store changes and go back to the starting point
for Channel 0 settings.
Review Channel 0 Values
Press the [FCN] key repeatedly to display each value in Channel 0,
and then return to the Channel 0 starting point.
Contents