Specifications

Installation and Programming DPH Series VHF Radio

Page 2-8 BK RADIO

To set Busy Channel operation use the following chart:

FUNCTION 2 FUNCTION 3

BUSY CHANNEL INDICATION

BUSY CHANNEL LOCKOUT

BUSY CHANNEL OVERRIDE

DISABLE (STEADY)

ENABLE (FLASHING)

DISABLE (STEADY)

2.2.2.8.3 ANI/DTMF Mode

When function 4 is enabled (flashing) the ANI ID number will be

transmitted (as a DTMF tone sequence) with each press of the PTT

switch. See "Automatic Numeric Identification (ANI)" in section 2.2.2.2 for

instructions on setting the ANI number.

When function 5 is enabled (flashing) the keypad becomes active for

manual DTMF operation.

When functions 4 and 5 are both enabled (flashing) the ANI tone

sequence will be transmitted only after the [ENT] key is pressed while

the transmit PTT switch is activated. A sidetone of the ANI number

transmitted will also be heard through the speaker.

2.2.2.8.4 Store Group Two Settings

Once each function 1-5 is set as desired, you can store the changes,

discard the changes, or disable all 5 functions.

Press the [CLR] key to disable all Group Two functions (steady).

Press the [ENT] key to store new Group Two settings into memory and

advance to the next section.

Press the [FCN] key to advance to the next section without saving

changes.

Note: Alphanumeric displays advance to Group Three Settings. 7-

Segment displays go back to the starting point for Channel 0 Settings.

2.2.2.9 Channel 0 Group Three Functions

After Group Two functions are set, the display will show PRG 3-12345

for Group Three functions. As with Group One and Group Two functions,

the enabled function numbers will flash. The disabled functions remain

steady.

2.2.2.9.1 Backlight on Display Change

When function 1 is enabled (flashing), the display backlight will illuminate

each time the display receives input. This includes displayed changes in

the selected channel or scan channel, and the PR, TX, and SCN

annunciators. The display will not illuminate if backlight duration is set to

LITE OFF. See "Backlight Duration."