Specifications

DPH Series VHF Radio Installation and Programming
BK RADIO Page 2-5
2.2.2.4 Scan Delay Time
After the Time Out Timer is set, the upper display will indicate PRG SCN.
This is the scan delay time in seconds.
1. Press the [PRI] key to increase the scan delay time by .5 seconds, up to
7.5 seconds. Press the [PRI] key again to change the time from 7.5
seconds to 0.
2. Press the [CLR] key to reset the scan delay time to 0.
3. Press the [ENT] key to store the changed setting and advance to the
next section.
4. Press the [FCN] key to advance to the next section if no change is
needed.
2.2.2.5 Priority 1 Channel
After the Scan Delay is set, the display will indicate PRG PR1. The Priority 1
Channel can be programmed as a fixed channel, tied to the Channel Selector
knob, or programmed OFF. If the radio is programmed to transmit on the
first priority channel, transmissions will occur on PR1, if PR1 isn’t
programmed OFF, when operating in Single or Dual Priority Scan mode.
If PR1 is a fixed channel, and the [PRI] key on the keypad is not locked out,
during normal radio operation the user can move the channel selector to a
new channel and press the PRI key to choose a new PR1 channel.
1. Press the [PRI] key to cycle through the priority channel options, or enter
a fixed priority channel using the number keys.
Setting the channel to ON ties the PR1 channel to the channel selector
knob. Pressing [CLR] or the [0] key turns the PR1 channel OFF.
2. Press the [ENT] key to store the new priority channel and advance to the
next section.
2.2.2.6 Priority 2 Channel
After the Priority 1 Channel is set, the display will indicate PRG PR2. The
Priority 2 Channel can be programmed as a fixed channel, tied to the
Channel Selector knob, or programmed OFF.
The PR2 channel cannot be altered during normal radio operation.
1. Press the [PRI] key to cycle through the priority channel options, or enter
a fixed priority channel using the number keys.
Setting the channel to ON ties the PR2 channel to the channel selector
knob. Pressing [CLR] or the [0] key turns the PR2 channel OFF.
2. Press the [ENT] key to store the new priority channel and advance to the
next section.
123
456
789
0
*
#
CLR
FCN
PRI
ENT